How to make a MiniatureToaster, 1:12 scale

How to make a miniature toaster, 1:12 scale. This toaster is in my Kitchen Room Box and my First Apartment Room Box. It's modeled after the classic ToastMaster toasters. I've given a diagram with measurements. If you would like actual patterns, please e-mail me.

Set A: cut 2 pieces #1 from 1/16" thick basswood
Set B: cut 3 pieces #2 from 1/16" thick basswood
Set C: cut 2 pieces #2 from 3/32" thick basswood

The two 3/32" thick pieces from pattern#2 are the toast slots. I use a scroll saw to cut out my wood.
To cut the patterns all the same glue the wood together with paper between. Rough cut, about a 2"x 2", something you feel comfortable with under the blade. Now cut paper the same size. For pattern #1 cut one piece of paper. Use glue stick to glue the paper to one of the 1/16"x 2"x 2" pieces of basswood. Now glue stick on the paper and glue the second piece of 1/16"x 2"x 2" basswood on top, making a sandwich. Hold this together for a couple of minutes or use a small clamp to secure.
Cut 3 pieces 1/16"x 2"x 2" of basswood and 2 pieces 3/32"x 2"x 2" basswood. Cut 4 pieces of paper. Glue the paper between the basswood as before, clamp.
Trace the patterns onto the the stacks and cut out. Separate set A, separate set B from set C. Leave set C together for now. Separate set B. **I have found the best way to separate the pieces is to slide the stacks like you are opening a fan. Peel the paper off and sand lightly.**
Set C will be the toaster slots. Cut out the slot on the scroll saw. Now separate them.
Using wood glue, glue: B to C to B to C to B together, keep all edges even, clamp and let dry.
Glue one of A to each side of your toaster assembly matching the bottoms, let dry.
Glue the bottom onto the center of the bottom of the toaster.
To have a smooth look to the toaster, paint the end grain of the center section with gesso, let dry, sand and repeat.
Use a oval "Woodsie" for the handles. I sand thin on each end before I cut off the tips for the handles. Glue onto toaster into the seam where the bottom and toaster meet. Sand the end of another "Woodsie" for the lever. I used a rounded end of a toothpick for the "lightness/darkness" knob.
Scrape a slot in one end of the toaster, in the center of 1/16" piece of basswood. Glue the lever at the top of this slot and the knob at the bottom.
Drill a hole into the other side of the toaster, in the seam where the bottom is glued onto the toaster. This will be for the electrical cord, made from painted wire or string. I made the plug from polymer clay, but you could carve it from wood and glue onto the cord.
I used Delta's Permenamel black and silver, and Permenamel Clear Gloss Glaze. Paint the inside of the toaster black along with the bottom, lever, knob, cord and plug. Paint the toaster silver. Finish with the clear gloss glaze.


I hope you like your new toaster, this fits in the late 1930's up to now, I've seen these in the stores.